MTE watch winder modules WTM, made in germany - The module is suitable for individual or multiple use, preferred installation position 12° inclination backwards reversing mode or optional left / right run, duration of one cycle 72 seconds (rotation and break time), power supply via battery compartment or mains-plug transformer (adapter), as from 5 stations we recommend our central control, here each station can be programmed individually, low current consumption, very low-noise run. Dimensions: h 100, w 120, d 60 mm. (Battery compartment and mains-plug transformer is not incl.) Size: 12cm x 10cm x 5,7cm.
Learn More
Control-Unit with LED-Signal for MTE WTM and WTR watch winder modules. Options 1: TPD approx. 650 / 850 / 950 rotations within 12 hours (+12 hours off-time). Options 2: off / left rotation / right rotation / reversing rotation (alternating left rotation and right rotation). Options 3: express winding (continuous rotation without interruption). Learn More
Replacement motor for MTE WTS 4 220-240 volt watch winder. Due to its design, this motor is not suitable for watch winders of other brands. Although these types of watch winder motors are very durable, they are still subject to minimal wear and tear. After replacing the motor, your watch winder will run for many years. Repairing your watch winder is cheaper than buying a new one and protects the environment. Learn More
MTE SMALL double-metal-spring black for ladies-watches or watches with short strap, coated for MTE Modul WTA (also suitably for watch winders of the WTA and WTB series). Learn More
WTA assembly set is a watch winder module. This module is equipped with the new drive. Preferred mounting position: 12° backwards. Holding position for the watch is in the centre over shaft Ø 5 mm. Dowel pin Ø 3 mm. Cable set switch / electrical bed plate, power jack / battery clips soldered. Cycle: manual selection of direction, stop cycle about 65 seconds, Position of switch: Left -0- Right, Connected load: 3 V DC. Weight: 155 grams. Learn More